AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Nissan - P0130 2008 Nissan Altima Sedan

P0130 2008 Nissan Altima Sedan Code - Air Fuel Ratio Circuit Bank 1 Sensor 1

- Code Popularity: 4,111 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0130 2008 Nissan Altima Sedan?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Air fuel ratio (A/F) sensor bank 1 sensor 1
  • Air fuel ratio (A/F) sensor bank 1 sensor 1 harness is open or shorted
  • Air fuel ratio (A/F) sensor bank 1 sensor 1 circuit poor electrical connection
  • Inappropriate fuel pressure
  • Faulty fuel injectors
  • Intake air leaks may be faulty
  • Exhaust gas leaks
⚠ Does your Nissan have Safety Recalls? → Check here

How to Fix the DTC P0130 2008 Nissan Altima Sedan?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Replacing the Air fuel ratio (A/F) sensor bank 1 sensor 1 usually takes care of the problem.

Search for P0130 2008 Nissan Altima Sedan Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0130 2008 Nissan Altima Sedan code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

The Air Fuel Ratio (A/F) signal computed by Engine Control Module (ECM) from the A/F sensor 1 signal is constantly in the range other than approx. 1.5V.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • High Fuel Consumption
  • Excessive Smoke from Exhaust

Code P0130 2008 Nissan Altima Sedan Description

The Air Fuel Ratio (A/F) sensor is a planar dual-cell limit current sensor. The sensor element of the A/F sensor is the combination of a Nernst concentration cell (sensor cell) with an oxygen-pump cell, which transports ions. It has a heater in the element.
The sensor is capable of precise measurement λ= 1, but also in the lean and rich range. Together with its control electronics, the sensor outputs a clear, continuous signal throughout a wide range (0.7 < λ < air).
The exhaust gas components diffuse through the diffusion gap at the electrode of the oxygen pump and Nernst concentration cell, where they are brought to thermodynamic balance. An electronic circuit controls the pump current through the oxygen pump cell so that the composition of the exhaust gas in the diffusion gap remains constant at λ = 1. Therefore, the A/F sensor is able to indicate air/fuel ratio by this pumping of current. In addition, a heater is integrated in the sensor to ensure the required operating temperature of 700 - 800°C (1,292 - 1,472°F).

OBDII Code P0130 2008 Nissan Altima Sedan - Air Fuel Ratio Circuit Bank 1 Sensor 1 - AutoCodes.com
P0130 2008 Nissan Altima Sedan Code - Air Fuel Ratio Circuit Bank 1 Sensor 1

Need More Information on the Code?

Need more information on how to fix the P0130 2008 Nissan Altima Sedan code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0130 2008 Nissan Altima Sedan code diagnosed by a professional: Find a repair shop in your area

Code P0130 2008 Nissan Altima Sedan comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0130 2008 Nissan Altima Sedan code? Have you replaced any parts?
Any information is appreciated. Thanks