AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Jeep - P0152 Jeep

P0152 Jeep Code - O2 sensor 2/1 Circuit High

- Code Popularity: 37,656 Views
- Repair Importance Level: 2/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0152 Jeep?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Front Heated Oxygen Sensor Bank 2
  • Intake air leaks may be faulty
  • Exhaust gas leaks
  • Front Heated Oxygen Sensor Bank 2 harness is open or shorted
  • Front Heated Oxygen Sensor Bank 2 circuit poor electrical connection
  • Inappropriate fuel pressure
  • Faulty fuel injectors
⚠ Does your Jeep have Safety Recalls? → Check here

How to Fix the DTC P0152 Jeep?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Replacing the Front Heated Oxygen Sensor Bank 2 usually takes care of the problem.

Search for P0152 Jeep Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0152 Jeep code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

An excessively high voltage from the sensor is sent to Engine Control Module (ECM).

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • High Fuel Consumption
  • Excessive Smoke from Exhaust

Code P0152 Jeep Description

The front heated oxygen sensor (or O2 sensor 1) is placed into the exhaust manifold. It detects the amount of oxygen in the exhaust gas compared to the outside air. The heated oxygen sensor 1 has a closed-end tube made of ceramic zirconia. The zirconia generates voltage from approximately 1V in richer conditions to 0V in leaner conditions. The heated oxygen sensor 1 signal is sent to the Engine Control Module (ECM). The ECM adjusts the injection pulse duration to achieve the ideal air-fuel ratio. The ideal air-fuel ratio occurs near the radical change from 1V to 0V.

OBDII Code P0152 Jeep - O2 sensor 2/1 Circuit High - AutoCodes.com
P0152 Jeep Code - O2 sensor 2/1 Circuit High

Need More Information on the Code?

Need more information on how to fix the P0152 Jeep code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0152 Jeep code diagnosed by a professional: Find a repair shop in your area

Code P0152 Jeep comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0152 Jeep code? Have you replaced any parts?
Any information is appreciated. Thanks