AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - P0300 2012 Ford Fusion

P0300 2012 Ford Fusion Code - Random Misfire Detected

- Code Popularity: 9,883 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0300 2012 Ford Fusion?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty spark plug (s)
  • Low fuel
  • Faulty ignition coil (s)
  • Clogged or faulty fuel injector (s)
  • Intake air leak
  • Exhaust gas recirculation (EGR) system blocked or stuck open
  • Fuel injectors harness is open or shorted
  • Fuel Injectors circuit poor electrical connection
  • Ignition coils harness is open or shorted
  • Ignition coils circuit poor electrical connection
  • Camshaft position sensor
  • Insufficient cylinders compression
  • Incorrect fuel pressure
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P0300 2012 Ford Fusion?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

The P0300 code means that a cylinder(s) is misfiring or is randomly misfiring. Start by checking for intake leaks, intake gaskets are common caused of multi-cylinder misfiring. If no leak are found the next step is to replace the spark plugs. If the problem persists more tests needs to be done to diagnose problem, see "Possible Causes"

Search for P0300 2012 Ford Fusion Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0300 2012 Ford Fusion code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

The random misfire DTC indicates multiple cylinders are misfiring or the powertrain control module (PCM)

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/loss of power
  • Hard start
  • Engine hesitation

Code P0300 2012 Ford Fusion Description

When a misfire occurs, engine speed will fluctuate. If the engine speed fluctuates enough to cause the Crankshaft Position (CKP) sensor signal to vary, the Engine Control Module (ECM) can determine that a misfire is occurring.

OBDII Code P0300 2012 Ford Fusion - Random Misfire Detected - AutoCodes.com
P0300 2012 Ford Fusion Code - Random Misfire Detected

Need More Information on the Code?

Need more information on how to fix the P0300 2012 Ford Fusion code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0300 2012 Ford Fusion code diagnosed by a professional: Find a repair shop in your area

Code P0300 2012 Ford Fusion comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0300 2012 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks