AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Acura - P0301 Acura

P0301 Acura Code - No. 1 Cylinder Misfire Detected

- Code Popularity: 44,581 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0301 Acura?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Valve adjustment
  • Faulty spark plug #1
  • Faulty ignition coil #1
  • Clogged or faulty fuel injector #1
  • Intake air leak
  • Insufficient cylinder #1 compression
  • Incorrect fuel pressure
⚠ Does your Acura have Safety Recalls? → Check here

How to Fix the DTC P0301 Acura?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

The P0301 code means that cylinder #1 is misfiring or is randomly misfiring. Start by checking for intake leaks and if no leaks are found the next step is to replace the spark plugs on cylinder #1. If the problem persists more tests need to be done to diagnose the problem, see "Possible Causes".

Search for P0301 Acura Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0301 Acura code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/loss of power
  • Hard start
  • Engine hesitation

Code P0301 Acura Description

The crankshaft vibrates slightly when each cylinder fires. If a misfire occurs, the crankshaft rotation speed changes rapidly. The Powertrain Control Module (PCM) monitors the crankshaft rotation speed based on the output pulses from the Crankshaft Position (CKP) Sensor. By monitoring changes in the crankshaft rotation speed, the PCM counts the number of misfires and determines which cylinder is misfiring. If a misfire is detected, a Diagnostic Trouble Code (DTC) is stored.
There are two types of misfire detection: Type 1: When the number of misfires per 200 engine revolutions reaches the level that can damage the three-way catalyst (TWC), a DTC is stored and the MIL blinks. Type 2: When the number of misfires per 1,000 engine revolutions reaches the level that affects exhaust emissions but is not severe enough to immediately damage the catalyst, a DTC is stored, and the MIL comes on.

OBDII Code P0301 Acura - No. 1 Cylinder Misfire Detected - AutoCodes.com
P0301 Acura Code - No. 1 Cylinder Misfire Detected

Need More Information on the Code?

Need more information on how to fix the P0301 Acura code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0301 Acura code diagnosed by a professional: Find a repair shop in your area

Code P0301 Acura comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0301 Acura code? Have you replaced any parts?
Any information is appreciated. Thanks