AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Nissan - P0345 2005 Nissan Pathfinder

P0345 2005 Nissan Pathfinder Code - Camshaft Position Sensor Circuit Bank 2

- Code Popularity: 27,208 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0345 2005 Nissan Pathfinder?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Camshaft Position Sensor
  • Camshaft Position Sensor harness is open or shorted
  • Camshaft Position Sensor circuit poor electrical connection
  • Faulty starter motor
  • Starting system circuit
  • Dead (Weak) battery
⚠ Does your Nissan have Safety Recalls? → Check here

How to Fix the DTC P0345 2005 Nissan Pathfinder?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes





User Submitted Video

Search for P0345 2005 Nissan Pathfinder Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0345 2005 Nissan Pathfinder code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

The camshaft position sensor signal is not detected by the Engine Control Module(ECM) during the first few seconds of engine cranking

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of Power
  • Engine Stall

Code P0345 2005 Nissan Pathfinder Description

The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. This information is used by the Engine Control Module(ECM) to control ignition and fuel injection. The camshaft position sensor senses the retraction of camshaft (intake) to identify a particular cylinder. The camshaft position sensor senses the piston position. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.
When the crankshaft position sensor (POS) system becomes inoperative, the camshaft position sensor provides various controls of engine parts instead, utilizing timing of cylinder identification signals.

OBDII Code P0345 2005 Nissan Pathfinder - Camshaft Position Sensor Circuit Bank 2 - AutoCodes.com
P0345 2005 Nissan Pathfinder Code - Camshaft Position Sensor Circuit Bank 2

Need More Information on the Code?

Need more information on how to fix the P0345 2005 Nissan Pathfinder code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0345 2005 Nissan Pathfinder code diagnosed by a professional: Find a repair shop in your area

Code P0345 2005 Nissan Pathfinder comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0345 2005 Nissan Pathfinder code? Have you replaced any parts?
Any information is appreciated. Thanks