AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Scion - P0441 2006 Scion xB

P0441 2006 Scion xB Code - Evaporative Emission Control System Incorrect Purge Flow

- Code Popularity: 8,725 Views
- Repair Importance Level: 1/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0441 2006 Scion xB?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Missing Fuel cap
  • Incorrect fuel filler cap used
  • Fuel filler cap remains open or fails to close
  • Purge VSV
  • Connector/wire harness(purge VSV -ECM)
  • ECM
  • Canister pump module
  • Leakage from
  • EVAP system
⚠ Does your Scion have Safety Recalls? → Check here

How to Fix the DTC P0441 2006 Scion xB?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

The P0441 code means that the control module has detected a leak in the Evaporative Emission (EVAP). Loose fuel tank filler cap is the most common cause that triggers the P0441 code.

Search for P0441 2006 Scion xB Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0441 2006 Scion xB code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

Pressure in charcoal canister and fuel tank does not drop during purge control (2 trip detection logic)

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • A noticeable fuel odor may result from fuel vapor release

Code P0441 2006 Scion xB Description

The ECM monitors the Fuel Tank Pressure sensor in order to determine the level of vacuum/pressure in the EVAP system. The ECM commands both the EVAP Purge Solenoid and the EVAP Vent Valve ON when the conditions are met in order to apply an engine vacuum to the EVAP system. The ECM commands the EVAP Purge Solenoid OFF once the system has reached a predetermined level of vacuum. This test verifies if a vacuum can be achieved in the EVAP system. Failure to develop a vacuum may be caused by a large leak or a restriction.
OBDII Code P0441 2006 Scion xB - Evaporative Emission Control System Incorrect Purge Flow - AutoCodes.com
P0441 2006 Scion xB Code - Evaporative Emission Control System Incorrect Purge Flow

Need More Information on the Code?

Need more information on how to fix the P0441 2006 Scion xB code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0441 2006 Scion xB code diagnosed by a professional: Find a repair shop in your area

Code P0441 2006 Scion xB comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0441 2006 Scion xB code? Have you replaced any parts?
Any information is appreciated. Thanks