AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Infiniti - P1610 Infiniti

P1610 Infiniti Code - Lock Mode

- Code Popularity: 53,774 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P1610 Infiniti?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty or not programmed ignition key
  • Faulty IMMU
  • Faulty Engine Control Module (ECM)
⚠ Does your Infiniti have Safety Recalls? → Check here

How to Fix the DTC P1610 Infiniti?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

This code is usually triggered when a not registered or damaged key is used to start the engine. When the starting operation is carried out five or more times consecutively with the same unregistered key, the system will lock. If the problem occurs try disconnecting the car battery for about 30 minutes and then try starting the engine with a known registered key. If the problem persists you have to have the dealer erase the code and reprogram the keys again.

If problem persists after disconnecting the car battery, try the following:

ESCAPE FROM LOCK MODE
1. Turn ignition switch OFF.
2. Turn ignition switch ON with registered key. (Do not start engine.) Wait 5 seconds.
3. Return the key to OFF position.
4. Repeat steps 2 and 3 twice (total of three cycles).
5. Start the engine.





User Submitted Video

Search for P1610 Infiniti Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1610 Infiniti code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

When the starting operation is carried out five or more times consecutively with an unregistered ignition key or faulty key.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine would not start

Code P1610 Infiniti Description

An immobilizer is an electronic device fitted to an automobile which prevents the engine from running unless the correct key is present. This prevents the car from being hotwired after entry has been achieved.
The microcircuit inside the key is activated by a small electromagnetic field which induces current to flow inside the key body, which in turn broadcasts a unique binary code which is read by the automobile's Engine Control Module (ECM). When the ECM determines that the coded key is both current and valid, the ECM activates the fuel-injection sequence.
The immobilizer function of the Infiniti Vehicle Immobilizer System (IVIS) or Nissan Anti-Theft System (NATS) consists of the following:
- NATS ignition key
- NATS antenna amp. located in the ignition key cylinder
- Body control module (BCM) or (IMMU)
- Engine Control Module (ECM)
- Security indicator lamp

OBDII Code P1610 Infiniti - Lock Mode - AutoCodes.com
P1610 Infiniti Code - Lock Mode

Need More Information on the Code?

Need more information on how to fix the P1610 Infiniti code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1610 Infiniti code diagnosed by a professional: Find a repair shop in your area

Code P1610 Infiniti comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1610 Infiniti code? Have you replaced any parts?
Any information is appreciated. Thanks