AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Nissan - U0101 2012 Nissan Rogue

U0101 2012 Nissan Rogue Code - Lost Communication with Transmission Control Module

- Code Popularity: 4,235 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC U0101 2012 Nissan Rogue?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Transmission Control Module (TCM)
  • Transmission Control Module harness is open or shorted
  • Transmission Control Module circuit poor electrical connection
  • Faulty Engine Control Module (ECM)
⚠ Does your Nissan have Safety Recalls? → Check here

How to Fix the DTC U0101 2012 Nissan Rogue?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for U0101 2012 Nissan Rogue Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the U0101 2012 Nissan Rogue code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code U0101 2012 Nissan Rogue Description

The Controller Area Network (CAN) is a serial communication line for real-time applications. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads the required data only.
If the Transmission Control Module (TCM) cannot communicate with the Engine Control Module (ECM), the TCM will conclude that there is a malfunction in the CAN system, illuminate the MIL, and set a Diagnostic Trouble Code (DTC).

OBDII Code U0101 2012 Nissan Rogue - Lost Communication with Transmission Control Module  - AutoCodes.com
U0101 2012 Nissan Rogue Code - Lost Communication with Transmission Control Module

Need More Information on the Code?

Need more information on how to fix the U0101 2012 Nissan Rogue code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the U0101 2012 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area

Code U0101 2012 Nissan Rogue comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U0101 2012 Nissan Rogue code? Have you replaced any parts?
Any information is appreciated. Thanks