DIY
Cautions: Disconnect both terminals from battery in advance. Be careful not to scratch finishers and other parts. Removal: 1. Remove shifter bezel. Pull bezel out or insert a flat screw driver between the bezel and center console to pry out the bezel.
2. Remove the radio and A/C control cover screws. There are four (4) Phillips screws, two at the bottom and two just above the radio.
3. Pull out the radio cover and disconnect power outlet connector and hazards light switch connector.
4. Once the cover is removed from the dash, locate and remove the four (4) Phillips screws that secures the radio metal bracket to the dash.
5. Disconnect the radio connectors, antenna and remove radio
Installation: Install in reverse order. |
|