Click image to see it larger

1. Remove the Rear door finisher. See: 2003-2007 Rear Door Panel Removal Procedure

2. Remove the rear door outside molding.

Click image to see it larger

a. Open windows fully.

b. Disengage rear door outside molding pawl.

c. Reaching from inner side of door use a clip tool to disengage rear door outside molding from the pawl.

Click image to see it larger

NOTE: Insert clip clamp tool into the door pawl, then disengage by pressing in the direction of arrow (see figure on the right).

3. Remove the sealing screen.

4. Remove the rear lower sash.

5. Operate the power window main switch to raise/lower the door window until the glass mounting bolts can be seen.

6. Remove the glass mounting bolts.

Click image to see it larger

7. Raise up the door glass and hold with a suction lifter or anything that can hold the window up.

Click image to see it larger

8. Remove the mounting bolts, and remove the module assembly.

9. Disconnect the harness connector for the module assembly, and unclip the harness from the back.

Click image to see it larger

10. Install in the reverse order of removal.

Nissan Murano DIY Projects
Modifications	Engine & Transmission	Air Bag & Body Exterior/Interior	OEM Accessories Installation Guides
Electrical & Audio	Heater & Air Condition	Suspension, ABS, Brakes & Tires	Engine Control System